|
Faults
|
Possible Reasons
|
Solving Methods
|
|
Serious leakage between plates (plates and frames).
|
Deformation of plates and frames
|
Replace
|
|
There are impurities on the sealing surface.
|
Clean
|
|
|
Clothes are not flat.
|
Replace or flat them.
|
|
|
Closing pressure is not enough.
|
Increase the closing pressure.
|
|
|
Deformation of plates or frames.
|
The filtering pressure is too high.
|
Decrease the pressure.
|
|
The temperature of slurry is too high.
|
Decrease the temperature
|
|
|
The closing pressure is too high.
|
Adjust the closing pressure.
|
|
|
The filtering speed is too fast.
|
Slow down the filtering speed.
|
|
|
The inlet is blocked.
|
Clean the inlet.
|
|
|
Beams bend.
|
The foundation is not firm and flat.
|
Repair or rebuilt.
|
Email：info@gaodetec.com .jpg)
.jpg)
